Competitors

Foot-O Competitors

Instructions for competitors using Contact-Free HC-Card punching in Foot-O

Step 1、Contact-Free HC-Card Wearing Guide

During competition, wear the HUIHCANG Contact-Free HC-Card on your finger.

In contact-free mode, briefly holding the card within 0-30 cm of a CF Station will trigger a successful punch, indicated by the card's LED light flashing along with audible and vibration feedback for about 3 seconds.

Key Reminder
Observing the light flash and feeling the vibration are essential, as they are the primary confirmation of a correctly executed punch。

Before the race starts, always check your card's battery：

Adequate Charge: Breathing light flashes green – card is operational.
Low Charge: Breathing light flashes red – requires immediate charging.

For a demonstration on how to punch effectively, click the video below. Watch the example and remember to pay attention to the sound, light, and vibration!

Step 2、CF Station Specifications

Punching Modes: Supports both contact-free and contact punching simultaneously.
Sensing Range: Effective stationary punching distance is 30 cm; sensing distance decreases during high-speed motion.
Device Configuration: The station must be clearly visible and fixed to a support pole.
Pole: pole types include wood and fiberglass.

Step 3、Participant Competition Process

1. Check-In

First, punch the Clear Station using the Contact-Free HC-Card in contact mode to ensure the erasure of all data from the previous competition stored on the card.
Next, punch the Check Station also in contact mode to activate the card.
If the card emits audible, visual, and vibration cues, it indicates successful activation and sufficient battery level. If no cues are provided, it signifies the card's battery is depleted (in this case, the card can only be used in contact mode for the duration of the event).

2. Start

The Start Station can be configured for either contact or contact-free punching. Athletes must select the corresponding method based on the officially published pre-event information to punch and officially initiate their race timing.

3. Control Points

Follow the course as designated on the competition map, punching all required CF Stations sequentially and accurately.

4. Finish

Complete the race by punching the Contact-Free Finish Mat (allowing a full-speed crossing) or by punching a designated Finish CF Station set up at the finish line.

5. Results Retrieval

After finishing, proceed to the results area and punch the Master Station with the Contact-Free HC-Card to upload the individual's complete race data to the computer system.

Ski-O Competitors

Instructions for competitors using Contact-Free HC-Card punching in Ski-O

Step 1、Contact-Free HC-Card Wearing Guide

During competition, wear the HUIHCANG Contact-Free HC-Card on your finger. If wearing gloves, it may be worn either inside or outside the glove

In contact-free mode, briefly holding the card within 0-30 cm of a CF Station will trigger a successful punch, indicated by the card's LED light flashing along with audible and vibration feedback for about 3 seconds.

Key Reminder
Observing the light flash and feeling the vibration are essential, as they are the primary confirmation of a correctly executed punch.

Before the race starts, always check your card's battery：

Adequate Charge: Breathing light flashes green – card is operational.
Low Charge: Breathing light flashes red – requires immediate charging.

For a demonstration on how to punch effectively, click the video below. Watch the example and remember to pay attention to the sound, light, and vibration!